JAD  X-Tract Delta 48 / 482
Entry level Delta PLC-based data acquisition system for dyno engine testing

The X-Tract Delta is a simple and cost effective measurement system used in dynamometer test bays. This instrumentation panel is used for the measurement of temperatures, pressures, speed and torque as well as the housing of an optional throttle controller system. X-Tract Delta uses Modbus communication over standard TCP/IP networks allowing any networked PC access to the measured data.

The system includes an X-Tract software licence as a pure logger for X-Tract Delta 48 and control ability with scripting for X-Tract Delta 482.

Advantages

  • Constructed from off the shelf hardware.
  • Good value for money.
  • Tried and tested.
  • Full documentation included.
  • Supported by a passionate technical team.
  • Full featured X-Tract software environment with: predefined test templates, automated run sequences (482 only), reporting engine for spread sheets.
  • Easy to use.
  • Easy to calibrate.
  • Many useful built in features

Specifications

  • 4 x Pressure channels (range as per your requirement between 1 and 400 Bar).
             - Termination in JIC 7/16 male
                fitting
             - 0.5% accuracy range
  • 4-20mA 0-10V + relay outputs (482 only).
  • 8 x K-Type thermocouple input channels.
  • Speed range 10 – 10000Rpm 0.1%.
  • Torque 0 – 2mv/v 0.1%.
  • Closed loop control for cooling system included in functionality (482 only).