JAD Systems
  • Home
  • About
  • Products
    • Brakes & Clutches >
      • Compressed air-cooled hysteresis brakes
      • Hysteresis clutches
      • Large bore brakes
      • Matched hysteresis brakes
      • Permanent magnet
      • Pure hysteresis brakes
    • Dynamometers >
      • Magtrol hysteresis dynamometers
      • Magtrol eddy current dynamometers
      • Magtrol powder dynamometers
      • Schenk eddy current dynamometers
      • Schenk water brake dynamometers
      • Custom dyno test beds
    • JAD Electronic products >
      • JAD 3 phase CT VT card
      • JAD digital filter board
      • JAD FDV board
      • JAD IYEV throttle controller
      • JAD LCA
    • JAD Mechanical products >
      • JAD Dual Reticulating Boom Arm
      • JAD Instrumentation Enclosure
    • JAD Software & systems >
      • JAD Mobiterm LEN7 software
      • JAD PowerMon
      • JAD T-Can Engine Protection System
      • JAD X-Var MLT16
      • JAD X-Tract 4
      • JAD X-Tract Delta 48x
      • JAD X-tract Terminal
      • JAD X-Zec 5-W
      • JAD X-Zec 5-WA
    • Measurement solutions >
      • Digital displays
      • Linear potentiometers
      • Linear resistive encoders
      • Magnetic linear encoders
      • Magnetic rotary encoders
      • Optical linear encoders
      • Optical rotary encoders
      • Process displays
      • Wire encoders
    • Pressure transducers >
      • BCT110 Piezoresistive Pressure Sensor
      • BT214 G1/2 Pressure Transmitter
      • BT214 G1 Pressure Transmitter
      • PTC Small Pressure Transmitters
      • PTL Submersible Level Transmitters
    • Torque transducers >
      • In line - TM series
      • In line - TMB series
      • In line - TMHS series
      • Torque Flange sensor - TF Series
      • Reaction torque sensors
      • Cardan shafts for TF sensors
      • Couplings for TF sensors
    • Rotary transmitters
    • Strain gauges
    • Special offers
  • Services
    • Calibration services
    • Custom dyno test beds
    • Engine dyno testing facilities
    • Software-Electronics research and design
  • Projects
    • Crowning pressure data logging
    • Data center monitoring
    • Electrical motor test bay
    • Electrical power and machine conditioning system
    • Hyperbaric Chamber
    • Impact analysis of falling elevator
    • Lawn mower test bed
    • Pump destruction testing
    • Pump efficiency test rig
    • Synchronised hydraulic press
  • Clients
  • Contact

JAD T-Can Engine Protection System

Picture
Dash mount module

JAD T-Can Engine Protection System
Scania engine protection

The T-Can Engine Protection System functions as a reliable and cost-effective engine protection system. JAD Systems' T-Can units are assembled and tested in-house, using a simulation and configuration platform developed specifically for the T-Can unit.

Features & overview

A Dash mount controller module
  • Based on an arm cortex micro controller;
  • Certified to comply with the vehicle directive standard;
  • Dual mode of communication available but set to operate as a pure listener device while installed, having no effect on the truck CAN communications network;
  • Configurable for various features, but as to Scania requirements currently protects the truck against coolant loss, overheating, oil pressure loss and idle abuse. 
  • Reports and records internal system failure or CAN sensor network failure;
  • Fail over to a non-intrusive default where truck is not disabled.

Kill Mode
  • On detection of critical conditions through the CAN network, the T-Can unit will display a warning signal, (an LED light) and then shut down the truck's engine within seconds;
  • The T-Can unit will not allow engine restart for ten minutes, thus allowing the engine to cool down. After ten minutes the unit allows restart of engine for 90 seconds in a limping mode to allow the truck driver to move the vehicle to a safe area;
  • When the problem that caused the failure has been repaired, the unit will no longer detect a critical condition and allow the truck to continue on its way, until another failure is detected;
  • Note that the LED warning signals will stay active for ten minutes after a failure has been detected, however if the fault is repaired within that time the kill mode will deactivate as soon as it detects no failure/critical condition.

Wiring harness
  • Installation without disturbance or splicing /weakening of the truck wiring.

JAD T-Can software
  • Configuration of wiring and cut out profiles;
  • Download internal error log;
  • Download truck events;
  • Test features to diagnose system problems;
  • Module serial number allocation;
  • Module version and firmware features;
  • CAN bus mode configuration.

Downloads

JAD Systems T-Can product sheet
JAD X-Tract software agreement

HOME  |  ABOUT  |  PRODUCTS  | SERVICES  |  PROJECTS  |  CLIENTS  |  CONTACT
i n n o v a t i v e   m e a s u r e m e n t   i n t e g r a t i o n

Picture
Picture
​Copyright JAD Systems 2015
  • Home
  • About
  • Products
    • Brakes & Clutches >
      • Compressed air-cooled hysteresis brakes
      • Hysteresis clutches
      • Large bore brakes
      • Matched hysteresis brakes
      • Permanent magnet
      • Pure hysteresis brakes
    • Dynamometers >
      • Magtrol hysteresis dynamometers
      • Magtrol eddy current dynamometers
      • Magtrol powder dynamometers
      • Schenk eddy current dynamometers
      • Schenk water brake dynamometers
      • Custom dyno test beds
    • JAD Electronic products >
      • JAD 3 phase CT VT card
      • JAD digital filter board
      • JAD FDV board
      • JAD IYEV throttle controller
      • JAD LCA
    • JAD Mechanical products >
      • JAD Dual Reticulating Boom Arm
      • JAD Instrumentation Enclosure
    • JAD Software & systems >
      • JAD Mobiterm LEN7 software
      • JAD PowerMon
      • JAD T-Can Engine Protection System
      • JAD X-Var MLT16
      • JAD X-Tract 4
      • JAD X-Tract Delta 48x
      • JAD X-tract Terminal
      • JAD X-Zec 5-W
      • JAD X-Zec 5-WA
    • Measurement solutions >
      • Digital displays
      • Linear potentiometers
      • Linear resistive encoders
      • Magnetic linear encoders
      • Magnetic rotary encoders
      • Optical linear encoders
      • Optical rotary encoders
      • Process displays
      • Wire encoders
    • Pressure transducers >
      • BCT110 Piezoresistive Pressure Sensor
      • BT214 G1/2 Pressure Transmitter
      • BT214 G1 Pressure Transmitter
      • PTC Small Pressure Transmitters
      • PTL Submersible Level Transmitters
    • Torque transducers >
      • In line - TM series
      • In line - TMB series
      • In line - TMHS series
      • Torque Flange sensor - TF Series
      • Reaction torque sensors
      • Cardan shafts for TF sensors
      • Couplings for TF sensors
    • Rotary transmitters
    • Strain gauges
    • Special offers
  • Services
    • Calibration services
    • Custom dyno test beds
    • Engine dyno testing facilities
    • Software-Electronics research and design
  • Projects
    • Crowning pressure data logging
    • Data center monitoring
    • Electrical motor test bay
    • Electrical power and machine conditioning system
    • Hyperbaric Chamber
    • Impact analysis of falling elevator
    • Lawn mower test bed
    • Pump destruction testing
    • Pump efficiency test rig
    • Synchronised hydraulic press
  • Clients
  • Contact