Hysteresis clutches

Hysteresis clutches are designed to be powered without the use of brushes or slip rings; being pure hysteresis devices,  there is never any fear of contamination due to wear particles or leaky seals.

Specifications

Model	Minimum Torque at Rated Current	Rated Current	Maximum Speed	Kinetic Power*		Pillow block
				5 minutes	continuous
	Nm	mA	rpm	W	W	Model
HCF-8M	0,0565	150	3600	60	15	4729
HCF-16M	0,113	270	3600	75	20	4729
HCF-32M	0,23	332	3600	90	25	4724
HCF-120M	0,85	200	3600	300	75	4725
HCF-250M	1,80	415	3600	450	110	4830
HCS-100	100 oz·in	200	3600	300	75	4755
HCS-210	210 oz·in	375	3600	450	110	4760
HCS-420	420 oz·in	460	3600	670	160	4759
Obsolete Clutch Models						Replaced With
(for information only—these clutches are no longer available
HCS-8	8 oz·in	197	3,600	60	15	HCF-8M
HCS-16	16 oz·in	192	3,600	75	20	HCF-16M
HCS-120	120 oz·in	200	3,600	300	75	HCS-100 / HCF-120M

 

* Kinetic power ratings are maximum values based on limiting coil and/or bearing temperature to approximately 100 ºC and should not be exceeded. Actual values in service may vary ±50% depending on mounting, ventilation, ambient temperature, etc. 
**  Standard coil voltage is 24 VDC. 90 volt, 12 volt and non-standard coil voltages are available on request.

---

Downloads

Drawings
HCF-8M
HCF-16M
HCF-32M
HCF-120M
HCF-250M
HCS-100
HCS-210
HCS-420

Typical performance curves
HCF-32M
HCF-120M

Pillow block drawings
HCF-8M
HCF-16M
HCF-32M
HCF-120M
HCF-250M