JAD Engine dyno test facilities for motor sport industry

Picture
f230hs speed torque curve for our dyno cell
JAD is pleased to announce the availability of a high spec engine dyno facility specially designed for the  motor sport industry.

To make use of the facility, simply book your day, pick up an engine trolley (we have 3 available) and arrive on your booked day to map your motor.

We have a dual screen in the dyno so you can load your own tuning software or use ours.

Features

Pressure measurement:
  •  1 x  -1 to 1 Bar
  • 2 x 0 to 16 Bar
  • 1 x 0-25 Bar

K-type thermo couple measurement channels

The dyno also performs barometric correction with the following high resolution input channels:
  • Barometric pressure
  • Humidity
  • Air intake temperature.

The brake has the following specifications:
  • Speed measurement 0-13000Rpm
  • Torque measurement 2000Nm
  • Max power 1000Bhp for 5 Minutes only.
  • 400 Hp 100% duty cycle.

Electronic throttle controller with actuator, voltage, PWM and frequency output.

Closed loop engine cooling water feed controlled via a PLC with warning system for over temp.

12V Battery and ECU supply feed in the cell

The dyno facility has the ability to control the motor in speed or torque mode making use of:
  • Manual control on the Schenck LSG2010 controller
  • Manual control via the JAD X-Tract software.
  • Automatic control via JAD X-Tract software pre-recorded scrips.

We also have a 5 gas Bosch gas analyser available at an additional R250/day cost.

The details

Users: Available for use by trained persons 

Location: SA premises only

Fee:  Please contact our offices 

Times: 07H00 to 17H00